Subaru Crosstrek Service Manual: Installation

CAUTION:

• If the sealing cover - front door gets broken, replace it with a new part.

• Apply a uniform bead of butyl tape.

• Attach the sealing cover - front door, keeping it from becoming wrinkled.

• Breaks in the bead will allow water leakage and contamination.

1. Install the sealing cover - front door.

(1) Forcefully push the butyl tape portion to prevent any floating on surface.

(2) When replacing the sealing cover, use the butyl tape.

Preparation items:

Butyl tape: 3M Butyl Rubber 8626 or equivalent

2. Install each part in the reverse order of removal.

NOTE:

Before installation, check the following items.

• Rod of the latch and actuator assembly - front is free from deformation.

• Grease is applied sufficiently to the rod joints of the latch and actuator assembly - front.

• Cable of the latch and actuator assembly - front is free from deformation such as fray.

• Grease is applied sufficiently to the cable joints of the latch and actuator assembly - front.

Removal

General description

Other materials:

Inspection
MECHANICAL(H4DO) > Cylinder BlockINSPECTION1. CYLINDER BLOCK & PISTON1. Visually inspect to make sure that there are no cracks, scratches or other damage.2. Use liquid penetrant tester on the important sections to check for fissures.3. Check that there are no traces of gas leaking or water le ...

Inspection
ENTERTAINMENT > Navigation SystemINSPECTION1. BASIC INSPECTION1. Using the Check List for Interview, ask the customer the condition of how the trouble occurred. Check List for Interview > CHECK">2. Check the battery. Battery > INSPECTION">3. Check the list of Diagnostics w ...

Airbag connector Procedure
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Airbag ConnectorPROCEDURE1. OCCUPANT DETECTION SYSTEM (BETWEEN AIRBAG REAR HARNESS AND SEAT HARNESS)1. How to disconnect:Press the lock arm (A) and disconnect the connector.CAUTION:When pulling the slide lock or disconnecting connector, be sure to hold th ...