Subaru Crosstrek Service Manual: Installation

1. FRONT DOOR PANEL

1. Put a wooden block on a jack and place the panel assembly - front door on it.

2. Apply grease to the sliding area of door hinges, and install the door hinge to vehicle.

3. Adjust the height by the jack, and temporarily install the panel assembly - front door to the upper hinge - front door and the lower hinge - front door.

NOTE:

• When installing the panel assembly - front door, make sure that a uniform clearance is created around the panel.

• Perform installation while paying attention to the assembly direction of the grommet.

4. Adjust the clearance around the panel assembly - front door. Front Door > ADJUSTMENT">

5. Tighten the bolts and nuts of the door hinge and the checker assembly - front door.

Tightening torque:

Refer to “COMPONENT” of “General Description”. General Description > COMPONENT">

6. Install door internal parts in the reverse order of removal.

NOTE:

Before installation, check the following items.

• Rod of the latch and actuator assembly - front is free from deformation.

• Grease is applied sufficiently to the rod joints of the latch and actuator assembly - front.

• Cable of the latch and actuator assembly - front is free from deformation such as fray.

• Grease is applied sufficiently to the cable joints of the latch and actuator assembly - front.

7. Connect door harness connector, and install the cover side sill - front.

1. Apply grease to the sliding area of door hinges, and install the door hinge to vehicle.

2. Adjust the height by the jack, and temporarily install the panel assembly - front door to the upper hinge - front door and the lower hinge - front door.

NOTE:

When installing the panel assembly - front door, make sure that a uniform clearance is created around the panel.

3. Adjust the clearance around the panel assembly - front door. Front Door > ADJUSTMENT">

4. Tighten the bolts and nuts of the door hinge and the checker assembly - front door.

Tightening torque:

Refer to “COMPONENT” of “General Description”. General Description > COMPONENT">

Removal

Front fender

Other materials:

Dtc p0459 evap system (cpc) purge control valve "a" circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0459 EVAP SYSTEM (CPC) PURGE CONTROL VALVE "A" CIRCUIT HIGHDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:Improper idlingCAUTION:After servicin ...

Note
VEHICLE DYNAMICS CONTROL (VDC) > Vehicle Dynamics Control SystemNOTEFor operation procedures of each component of the vehicle dynamics control system, refer to the respective section.• VDC control module & hydraulic control unit (VDCCM&H/U): VDC Control Module and Hydraulic Control ...

Dtc b28b5 +b circuit open
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B28B5 +B CIRCUIT OPENDetected when there is an open circuit in power supply line.NOTE:Refer to DTC B2814 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2814 POWER SUPP ...