EXHAUST(H4DO) > Rear Exhaust Pipe
INSTALLATION
1. Apply a coat of spray type lubricant to the mating area of cushion rubber.
2. Install the rear exhaust pipe to cushion rubber.
NOTE:
After assembling, degrease the lubricant which was applied to the cushion rubber while removing/installing.
3. Install the bolts and self-locking nuts which secure the muffler to the rear exhaust pipe.
NOTE:
Use a new gasket and self-locking nut.
Tightening torque:
48 N·m (4.9 kgf-m, 35.4 ft-lb)
4. Install the bolts, springs, and nuts which secure the center exhaust pipe to the rear exhaust pipe.
NOTE:
Use a new gasket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
5. Lower the vehicle.
Dtc p000c "a" camshaft position slow response bank 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P000C "A" CAMSHAFT POSITION SLOW RESPONSE BANK 2NOTE:For the diagnostic procedure, refer to DTC P0021. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0021 "A" CAMSHAFT P ...
65
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code65Cruise control command switch malfunction is detected.While the command switch is pressed ON for a long time (approximately two minutes), stuck ON condition is detected.TROUBLE SYMPTOM:• Cruise control cannot be se ...
Dtc p0366 camshaft position sensor "b" circuit range/performance bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0366 CAMSHAFT POSITION SENSOR "B" CIRCUIT RANGE/PERFORMANCE BANK 1NOTE:For the diagnostic procedure, refer to DTC P0365. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0365 CAMSH ...