EXHAUST(H4DO) > Front Exhaust Pipe
INSTALLATION
1. Set the front exhaust pip and center exhaust pipe to the vehicle, and temporally tighten the nuts which secure the front exhaust pipe to cylinder head.
NOTE:
Use a new gasket.
2. Install the bolts, springs, and nuts which secure the rear exhaust pipe to the center exhaust pipe.
NOTE:
Use a new gasket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
3. Tighten the bolts which secure the center exhaust pipe to the hanger bracket.
Tightening torque:
35 N·m (3.6 kgf-m, 25.8 ft-lb)
4. Tighten the nuts which hold front exhaust pipe to cylinder heads.
Tightening torque:
30 N·m (3.1 kgf-m, 22.1 ft-lb)
5. Connect the front oxygen (A/F) sensor connector (A) and rear oxygen sensor connector (B), and fasten the harness with the clip (C).
6. Install the under cover. Front Under Cover > INSTALLATION">
7. Lower the vehicle.
8. Connect the battery ground terminal. NOTE">
Vdc warning light and vdc indicator light do not go off
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Warning Light Illumination PatternVDC WARNING LIGHT AND VDC INDICATOR LIGHT DO NOT GO OFFDetecting condition:• Defective combination meter• Defective engine• Defective CAN communicationTrouble symptom:VDC warning light and VDC indic ...
Cleaning aluminum wheels
Promptly wipe the aluminum wheels
clean of any kind of grime or agent. If dirt
is left on too long, it may be difficult to
clean off.
Do not use soap containing grit to
clean the wheels. Be sure to use a neutral
cleaning agent, and later rinse thoroughly
with water. Do not clean the ...
Dtc c0056 g sensor abnormal
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0056 G SENSOR ABNORMALDTC DETECTING CONDITION:Longitudinal G sensor signal failureTROUBLE SYMPTOM:• ABS does not operate.• VDC does not operate.• EyeSight does not operate. ...