ENTERTAINMENT > Switches and Harness
INSTALLATION
1. SATELLITE SWITCH ASSEMBLY
CAUTION:
• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
• Do not allow harness and connectors to interfere or get tangled up with other parts.
• If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.
• If the steering wheel and steering angle sensor (steering roll connector) are removed, perform “VSC(VDC) Centering Mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">
• Securely install the switch. Improper insertion of the pin or claw of the switch may cause improper installation.
1. Align the center position of the steering roll connector. Roll Connector > ADJUSTMENT">
2. Install each part in the reverse order of removal.
NOTE:
Align the alignment marks on the steering wheel and the column assembly - steering.
Tightening torque:
Steering wheel: 39 N·m (3.98 kgf-m, 28.8 ft-lb)
Clearance:
Between cover assembly - column and steering wheel: 4 — 6 mm (0.16 — 0.24 in)
2. TELEMATICS BUTTON
The telematics button is a single unit with the spot map light or stereo camera cover assembly. For operation procedures, refer to “LIGHTING SYSTEM” section. Spot Map Light > INSTALLATION">
Basic screens
By operating the "
" or "
" switch on the
steering wheel, you can change the
screen that is always displayed.
Default screen
Digital speedometer
Menu screen entering screen
While this screen is selected, pull the "
/
SET" switch to enter the menu screen. ...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > FRESH/RECIRC Door ActuatorREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground ...
Dtc b2223 gerda malfunction
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2223 GERDA MALFUNCTIONDTC DETECTING CONDITION:When the system microcomputer can not send/receive the data with the image microcomputer normally.TROUBLE SYMPTOM:There is no display on the TFT. O ...