EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Purge Control Solenoid Valve
INSTALLATION
Install in the reverse order of removal.
NOTE:
• Hold the purge control solenoid valve unit by hand to prevent it from rotating together.
• Connect the vacuum hose as shown in the figure.
(a) | To intake manifold | (b) | To fuel pipe |
• Check that the vacuum hose is securely held to the intake manifold and intake manifold clip (A).
Tightening torque:
3.4 N·m (0.3 kgf-m, 2.5 ft-lb)
Dtc b1825 short in side airbag lh
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1825 SHORT IN SIDE AIRBAG LHDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Side airbag harness (LH) circuit is shorted.• Side airbag module (LH) is faulty.• Airbag control ...
Preparation tool
SEAT BELT SYSTEM > General DescriptionPREPARATION TOOL1. SPECIAL TOOL• SUBARU SELECT MONITORILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Selec ...
Removal
FRONT SUSPENSION > Front Ball JointREMOVAL1. Lift up the vehicle, and then remove the front wheels.2. Remove the under cover - front. Front Under Cover > REMOVAL">3. Remove the clamp - stabilizer bushing on the left and right sides.4. Remove the ball joint assembly.(1) Pull out the co ...