Subaru Crosstrek Service Manual: Installation

Subaru Crosstrek Service Manual / Emission control (aux. Emission control devices)(h4do) / Pcv hose / Installation

EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > PCV Hose

INSTALLATION

Install in the reverse order of removal.

Removal

EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > PCV HoseREMOVALCAUTION:Do not remove except when the PCV hose is broken.1. Disconnect the PCV hose A from the intake manifold and the PCV va ...

Pcv valve

...

Other materials:

Control module i/o signal Electrical specification
BODY CONTROL SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATIONDescriptionTerminal No.Signal (V or ?)NoteIgnition switch ON(Engine OFF)Ignition power supply (rear wiper)A5 ←> Chassis groundLess than 1.5 V > 10 — 13 VIgnition switch OFF > ONBattery power suppl ...

Specification
VEHICLE DYNAMICS CONTROL (VDC) > ABS Sequence ControlSPECIFICATION1. CONDITIONS FOR COMPLETION OF ABS SEQUENCE CONTROLWhen the following conditions develop, the ABS sequence control stops and ABS operation is returned to the normal control mode.• When the speed of at least one wheel reaches ...

Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Control Valve BodyINSPECTION• Check each part for damage or dust.• Measure the resistance of each solenoid, sensor and ground wire.NOTE:Measurement should be performed at a temperature of 20°C (68°F).• SolenoidSol ...