Subaru Crosstrek Service Manual: Installation

The front catalytic converter is integrated into the front exhaust pipe; therefore, refer to “Front Exhaust Pipe” for the installation procedure. Front Exhaust Pipe > INSTALLATION">

Removal

Fuel level sensor

Other materials:

Safety tips for installing child restraint systems
WARNING Child restraint systems and seatbelts in the Subaru Ascent can become extremely hot when the vehicle is exposed to sunlight. Always check the temperature of the restraint system before placing a child in it to prevent burns. Never use a seatbelt extender when installing a ...

Removal
LIGHTING SYSTEM > High-mounted Stop LightREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate UPR. Rear Gate Trim > REMOVAL">3. Remove the light assembly - high-mounted.(1) Remove the nut.(2) From the inside of the r ...

Dtc p2195 a/f /o2 sensor signal biased/stuck lean bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2195 A/F /O2 SENSOR SIGNAL BIASED/STUCK LEAN BANK 1 SENSOR 1DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Cle ...