Subaru Crosstrek Service Manual: Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR Pipe
INSTALLATION
1. Temporarily install the EGR pipe to the intake manifold and water pipe assembly, and tighten the EGR pipe in numerical order as shown in the figure.
NOTE:
Use a new gasket.
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
2. Install the throttle body to the intake manifold.
Tightening torque:
8.0 N·m (0.8 kgf-m, 5.9 ft-lb)
3. Connect the connector to the throttle body.
4. Install the air intake boot. Air Intake Boot > INSTALLATION">
5. Connect the battery ground terminal.
Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR PipeREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake ...
Other materials:
Caution
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > General DescriptionCAUTION1. The occupant detection system (passenger seat only) control module and the occupant detection sensor are fixed to the seat cushion frame. Never remove the occupant detection control module or the occupant detection sensor from ...
Component
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > General DescriptionCOMPONENT(1)Lid ASSY - sunroof(6)Deflector ASSY - sunroofTightening torque: N·m (kgf-m, ft-lb)(2)Weather strip(7)Rail ASSY - sunroofT1:4.5 (0.46, 3.3)(3)Sunshade ASSY(8)Link - drain sunroofT2:6 (0.61, 4.4)(4)Drain tube - sunroof( ...
Defogger and deicer
Rear window defogger
Outside mirror defogger (if equipped)
Windshield wiper deicer (if equipped)
The vehicle is equipped with a rear
window defogger. Some models are also
equipped with an outside mirror defogger
and/or windshield wiper deicer. The defogger
and deicer system is acti ...