Subaru Crosstrek Service Manual: Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR Control Valve
INSTALLATION
Install in the reverse order of removal.
NOTE:
Use new O-rings and gaskets.
Tightening torque:
22 N·m (2.2 kgf-m, 16.2 ft-lb)
Tightening torque:
3 N·m (0.3 kgf-m, 2.2 ft-lb)
Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR Control ValveREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) ...
Egr cooler
...
Other materials:
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Sub Level SensorINSTALLATION1. Install the fuel sub level sensor to the fuel tank.(1) Make sure the sealing portion is free from fuel or foreign matter before installation.(2) Align the cutout (B) as shown in the figure, and install the fuel sub level se ...
System temporary stop indicator
System temporary stop indicator
This indicator appears when the system is
used under the following conditions.
Extremely high or low temperatures
When abnormal voltage exists for the
vehicle battery
When the radar sensor is significantly
misaligned
Once the above conditions are ...
Dtc c2123 transmitter 3 no data
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2123 TRANSMITTER 3 NO DATANOTE:Refer to DTC C2124 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2124 TRANSMITTER 4 NO DATA"> ...
