Subaru Crosstrek Service Manual: Installation

1. Install the canister to the vehicle using bolts and nuts.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

2. Install the drain tube (A), vent tube (B) and purge tube (C) to the canister.

CAUTION:

• Check that there is no damage or dust on the quick connector. If necessary, clean the seal surface of the pipe.

• Make sure that the quick connector is securely connected.

Install the quick connector as shown in the figure.

3. Lift up the transmission jack gradually, and set the rear differential to the rear sub frame assembly.

NOTE:

When inserting the stud bolt into the bushing portion of the rear sub frame assembly, adjust the angle and location of transmission jack and jack stand.

4. Temporarily tighten the self-locking nuts which hold the rear differential to the rear sub frame assembly.

NOTE:

Use a new self-locking nut.

5. Set the rear differential member to the rear sub frame assembly and rear differential, and temporarily tighten the self-lock nuts which secure the rear differential member to the rear sub frame assembly and rear differential.

NOTE:

Use a new self-locking nut.

6. Remove the transmission jack from the rear differential.

7. Tighten the self-locking nuts which secure the rear differential member to the rear sub frame assembly and rear differential.

Tightening torque:

T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)

T2: 110 N·m (11.2 kgf-m, 81.1 ft-lb)

8. Tighten the self-locking nuts which secure the rear differential to the rear sub frame assembly.

Tightening torque:

70 N·m (7.1 kgf-m, 51.6 ft-lb)

9. Install the propeller shaft. Propeller Shaft > INSTALLATION">

10. Install the rear exhaust pipe. Rear Exhaust Pipe > INSTALLATION">

11. Lower the vehicle.

Removal

Drain separator

Other materials:

Installation
SECURITY AND LOCKS > Starter Cut RelayINSTALLATIONCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">Install each part in the reverse order of removal. ...

Operation
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > AT OIL TEMP Warning Light DisplayOPERATIONThe AT OIL TEMP light illuminates or blinks, when the ATF temperature is high and malfunction occurs in CVT.• At normal conditionAfter turning the ignition switch to ON, illuminates for 2 seconds th ...

Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Center DifferentialINSTALLATION1. Attach the center differential to transfer case.2. Install the transfer driven gear. Transfer Driven Gear > INSTALLATION">3. Install the transfer case together with the extension case assembly. Transfer Cas ...