Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Installation

DIFFERENTIALS > Rear Differential Front Member

INSTALLATION

1. Install the rear differential front member, and temporarily attach and tighten a new self-locking nut.

2. Remove the transmission jack.

3. Tighten the self-locking nut.

Tightening torque:

T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)

T2: 110 N·m (11.2 kgf-m, 81.1 ft-lb)

Removal
DIFFERENTIALS > Rear Differential Front MemberREMOVAL1. Disconnect the ground cable from battery.2. Lift up the vehicle.3. Support the rear differential using transmission jack, and then remove the ...

Rear differential front oil seal
...

Other materials:

Dtc p050a cold start idle control system performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P050A COLD START IDLE CONTROL SYSTEM PERFORMANCEDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine keeps running at higher speed than specified ...

Component
COOLING(H4DO) > General DescriptionCOMPONENT1. WATER PUMP(1)Water pump pulley(13)Clip(25)Gasket(2)Water pump ASSY(14)Water pipe hose RH(26)Engine coolant temperature sensor(3)Gasket(15)Water pipe ASSY (CVT model)(27)EGR control valve(4)Thermostat (engine side)(16)Preheater hose A(28)O-ring(5)Gask ...

Removal
STARTING/CHARGING SYSTEMS(H4DO) > StarterREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) securing the air cleaner case (rear) to the air intake boot.4. Loosen the clamp (C) which secures the throttle body t ...

© 2016-2025 Copyright www.sucross.com