Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Installation

COOLING(H4DO) > Water Pump

INSTALLATION

1. WATER PUMP PULLEY

1. Using the ST, install the water pump pulley.

ST1 18355AA000PULLEY WRENCH
ST2 18334AA030PULLEY WRENCH PIN SET

Tightening torque:

14 N·m (1.4 kgf-m, 10.3 ft-lb)

2. Install the under cover. Front Under Cover > INSTALLATION">

3. Lower the vehicle.

4. Install the radiator main fan & fan motor assembly. Radiator Main Fan and Fan Motor > INSTALLATION">

5. Install the V-belts. V-belt > INSTALLATION">

6. Install the V-belt cover.

Tightening torque:

7 N·m (0.7 kgf-m, 9.6 ft-lb)

7. Connect the battery ground terminal. NOTE">

2. WATER PUMP

1. Install the water pump to oil pan upper.

NOTE:

Use a new gasket.

Tightening torque:

6.4 N·m (0.7 kgf-m, 4.7 ft-lb)

2. Install the front exhaust pipe. Front Exhaust Pipe > INSTALLATION">

3. Install the water pump pulley. Water Pump > INSTALLATION">

4. Fill engine coolant. Engine Coolant > REPLACEMENT">

Removal
COOLING(H4DO) > Water PumpREMOVAL1. WATER PUMP PULLEY1. Disconnect the ground cable from battery. NOTE">2. Remove the V-belt covers.3. Remove the V-belts. V-belt > REMOVAL">4. ...

Engine cooling system trouble in general Inspection
COOLING(H4DO) > Engine Cooling System Trouble in GeneralINSPECTIONTroublePossible causeCorrective actionOver-heatinga. Insufficient engine coolantReplenish engine coolant, inspect for leakage, and ...

Other materials:

Dtc p0038 a/f / o2 heater control circuit high bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0038 A/F / O2 HEATER CONTROL CIRCUIT HIGH BANK 1 SENSOR 2DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear ...

How to read wiring diagrams
WIRING SYSTEM > Basic Diagnostic ProcedureHOW TO READ WIRING DIAGRAMS1. WIRING DIAGRAMThe wiring diagram of each system is illustrated so that you can understand the path through which the electric current flows from the battery.Sketches and codes are used in the diagrams. They should read as fol ...

Installation
BRAKE > Master CylinderINSTALLATION1. Replace the seal sub assembly for the master cylinder assembly with a new part.CAUTION:Be careful not to install the seal sub assembly in the wrong location.(a)Primary piston(b)Seal sub ASSY(c)Install the seal sub assembly to this surface.2. Install each part ...

© 2016-2025 Copyright www.sucross.com