COOLING(H4DO) > Thermostat
INSTALLATION
1. ENGINE SIDE
1. Install a gasket to thermostat.
NOTE:
Use a new gasket.
2. Install the thermostat and thermostat cover.
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
(A) | Thermostat cover | (B) | Gasket | (C) | Thermostat |
3. Connect the radiator outlet hose to thermostat cover.
4. Install the front exhaust pipe. Front Exhaust Pipe > INSTALLATION">
5. Install the under cover. Front Under Cover > INSTALLATION">
6. Lower the vehicle.
7. Connect the battery ground terminal. NOTE">
8. Fill engine coolant. Engine Coolant > REPLACEMENT">
2. CVTF COOLER (WITH WARMER FEATURE) SIDE
1. Install a gasket to thermostat.
NOTE:
Use a new gasket.
2. Install the thermostat and thermostat cover.
NOTE:
Install the parts with the air vent hole facing upward.
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
(A) | Thermostat cover | (B) | Gasket | (C) | Thermostat |
(D) | Air vent hole |
3. Connect the engine coolant hose to the thermostat cover.
4. Install the engine hanger to the cylinder block RH.
Tightening torque:
21 N·m (2.1 kgf-m, 15.5 ft-lb)
5. Connect the connector (A) to the manifold absolute pressure sensor.
6. Connect the connector (B) to the throttle position sensor.
7. Connect the connector (C) to the EGR control valve.
8. Connect the engine harness connector.
(1) Connect the bulkhead harness connector to the engine harness connector (black) and engine harness connector (brown).
(2) Install the bolt which secures the bulkhead harness connector bracket.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
9. Install the air intake boot. Air Intake Boot > INSTALLATION">
10. Lift up the vehicle.
11. Install the under cover. Front Under Cover > INSTALLATION">
12. Lower the vehicle.
13. Connect the battery ground terminal. NOTE">
14. Fill engine coolant. Engine Coolant > REPLACEMENT">
Dtc p0122 throttle/pedal position sensor/switch "a" circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0122 THROTTLE/PEDAL POSITION SENSOR/SWITCH "A" CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Engine stall• Poor driving perf ...
Temperature control
Type A
Turn the temperature control dial over a
range from the blue side (cool) to red side
(warm) to regulate the temperature of
airflow from the air outlets.
Type B, C and D
Turn the temperature control dial to set the
preferred interior temperature. With the
dial set to your preferred tem ...
Removal
CLUTCH SYSTEM > Clutch Pipe and HoseREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).4. Loosen the clamp (C) which connects the air intake boot and throttle body.5. ...