Subaru Crosstrek Service Manual: Installation

Install in the reverse order of removal.

CAUTION:

Confirm that the radiator hose is securely connected.

If the installation of the radiator main fan and fan motor is difficult, attempt installation after loosening the bolts which hold the radiator sub fan shroud to the radiator.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

Inspection

Radiator sub fan and fan motor

Other materials:

Removal
DRIVE SHAFT SYSTEM > Front Hub Unit BearingREMOVAL1. Lift up the vehicle, and then remove the front wheels.2. Remove the axle nut.CAUTION:Do not loosen the axle nut while the front axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the crimped section of axle nut.(2) Remove the axl ...

Pressure switch (triple pressure switch) Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Pressure Switch (Triple Pressure Switch)INSPECTION1. Connect the manifold gauge to the service valve on the high-pressure side.2. Disconnect the connector.3. Start the air conditioner, and check the operating pressure of switch by turning the compressor ...

Electrical component location Location
EyeSight (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Stereo camera(5)EyeSight steering switch(9)Transmission control module (TCM)(2)VDC control module (VDCCM)(6)MFD (multi-function display)(10)Stop light and brake switch(3)Brake light relay(7)Body integrated unit(11)ECM(4)Combination ...