Subaru Crosstrek Service Manual: Installation
CONTROL SYSTEMS > Select Cable
INSTALLATION
1. Position the select cable as shown in the figure, and install it to the plate assembly.
CAUTION:
• If the cable is installed in the wrong direction, loosen the bracket bolts, and then reinstall the cable in the correct direction.
• Do not adjust the cable end direction by turning it forcibly to prevent the boot from being twisted.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
(A) | Select cable |
2. Install the select cable to the shifter arm.
3. Install the plate assembly to transmission.
Tightening torque:
T: 25 N·m (2.5 kgf-m, 18.4 ft-lb)
(A) | Select cable |
(B) | Plate ASSY |
4. Install the washer and snap pin to the shifter arm.
CAUTION:
Do not apply extra overload while holding the part (A).
(A) | Shifter arm |
(B) | Snap pin |
(C) | Select cable |
(D) | Washer |
5. Install new clamp paying attention to the installing direction.
(A) | Clamp |
(B) | Forward |
6. Insert the tip of inner cable into connector hole of select lever, and fix the cable to bracket.
CAUTION:
Do not apply extra overload while holding the part (A).
7. Shift the select lever to the “N” range, and then adjust the select cable position. Select Cable > ADJUSTMENT">
8. Install the center exhaust cover.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
9. Install the center exhaust pipe. Center Exhaust Pipe > INSTALLATION">
10. Lower the vehicle.
11. Connect the battery ground terminal. NOTE">
Inspection
CONTROL SYSTEMS > Select CableINSPECTIONCheck the removed cable and replace or adjust if damaged, rusty or malfunctioning.1. Check the cable for smooth operation.2. Check the inner cable for damage ...
Select lever
...
Other materials:
Clock/calendar screen setting
1. Perform the preparation steps according
to "Preparation for screen settings"
2. Operate the "
" or "
"
switch to
select the "Clock" item. Then push the
button.
3. Push the
button once more.
4. Select "Analog Clock", "Digital Clock",
"Calendar" or "Off" by operating t ...
Disposal
FRONT SUSPENSION > Front StrutDISPOSALCAUTION:• Before handling the strut damper and shock absorber, be sure to wear goggles to protect eyes from gas, oil and cutting powder.• Do not disassemble the strut damper and shock absorber or place them into a fire.• When discarding gas ...
Dtc p013a o2 sensor slow response - rich to lean bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P013A O2 SENSOR SLOW RESPONSE - RICH TO LEAN BANK 1 SENSOR 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clea ...
