Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Installation

CONTROL SYSTEMS > AT Shift Lock Solenoid and “P” Range Switch

INSTALLATION

Install in the reverse order of removal.

NOTE:

Insert the solenoid unit terminals to the harness connector.

(A)

Solenoid unit (color code: blue)

(B)

Solenoid unit (color code: black)

Removal
CONTROL SYSTEMS > AT Shift Lock Solenoid and “P” Range SwitchREMOVAL1. SOLENOID UNIT1. Remove the AT select lever. Select Lever > REMOVAL">2. Remove the spacer and gasket. ...

General description
...

Other materials:

Installation
VEHICLE DYNAMICS CONTROL (VDC) > Front ABS Wheel Speed SensorINSTALLATIONCAUTION:• Be careful not to damage the sensor.• Do not apply excessive force to the sensor harness.Install each part in the reverse order of removal.NOTE:• Check the identification (mark) on the harness to ...

Cleaning ventilation grille
Front ventilation inlet grille Always keep the front ventilation inlet grille free of snow, leaves, or other obstructions to ensure efficient heating and defrosting. Since the condenser is located in front of the radiator, this area should be kept clean because cooling performance i ...

Dtc p219a bank 1 air-fuel ratio imbalance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P219A BANK 1 AIR-FUEL RATIO IMBALANCEDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine stall• Improper idlingCAUTION:After servicing or ...

© 2016-2024 Copyright www.sucross.com