Subaru Crosstrek Service Manual: Installation

1. Clean the mating surface of transmission case and converter case.

2. Select the reduction gear shim. Reduction Drive Gear > ADJUSTMENT">

3. Remove the transmission case, and install the selected reduction gear shim to the reduction drive gear.

4. Install the O-rings to the reverse clutch housing and drive pinion retainer.

NOTE:

• Use new O-rings.

• Apply CVTF to the O-rings.

5. Install the seal ring to the transmission case.

NOTE:

• Use new seal rings.

• When installing the seal rings, do not expand the seal rings too much.

• Apply CVTF to the seal rings.

6. Cover the secondary pulley with the oil baffle, and temporarily install it with bolts.

7. Apply liquid gasket seamlessly to the mating surface of transmission case.

Liquid gasket:

THREE BOND 1215B or equivalent

8. Install the transmission case.

NOTE:

The total number of transmission case mounting bolts is 15.

Tightening torque:

22 N·m (2.2 kgf-m, 16.2 ft-lb)

9. Install the oil cooler pipe.

NOTE:

Use new O-rings.

Tightening torque:

25 N·m (2.5 kgf-m, 18.4 ft-lb)

10. Install the oil baffle securing bolt.

Tightening torque:

16 N·m (1.6 kgf-m, 11.8 ft-lb)

11. Install the transmission control device. Transmission Control Device > INSTALLATION">

12. Install the oil pan and oil strainer. Oil Pan and Strainer > INSTALLATION">

13. Install the reduction driven gear assembly. Reduction Driven Gear > INSTALLATION">

14. Install the parking pawl. Parking Pawl > INSTALLATION">

15. Install the transfer driven gear assembly. Transfer Driven Gear > INSTALLATION">

16. Install the transfer clutch assembly. Transfer Clutch > INSTALLATION">

17. Install the extension case. Extension Case > INSTALLATION">

18. Install the inhibitor switch. Inhibitor Switch > INSTALLATION">

19. Install the secondary speed sensor. Secondary Speed Sensor > INSTALLATION">

20. Install the primary speed sensor. Primary Speed Sensor > INSTALLATION">

21. Install the turbine speed sensor. Turbine Speed Sensor > INSTALLATION">

22. Install the transmission harness. Transmission Harness > INSTALLATION">

23. Install the control valve body. Control Valve Body > INSTALLATION">

24. Install the air breather hose. Air Breather Hose > INSTALLATION">

25. Install the transmission assembly to the vehicle. Automatic Transmission Assembly > INSTALLATION">

Inspection

Transmission control device

Other materials:

Electrical
SPECIFICATIONS > CrosstrekELECTRICALModel2.0 L DOHC non-turboIgnition timing (at idling)BTDCMT: 12°±10°CVT: 16°±10°Spark plugType and manufacturerNGK: SILZKAR7B11Generator12 V — 130 ABatteryType55D23L75D23LNominal capacity5 HR: 40 Ah [25° ...

Dtc p050b cold start ignition timing performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P050B COLD START IGNITION TIMING PERFORMANCENOTE:For the diagnostic procedure, refer to DTC P050A. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P050A COLD START IDLE CONTROL SYSTEM PERFORM ...

Removal
FRONT SUSPENSION > Front CrossmemberREMOVALCAUTION:• The power steering control module continues to operate after the engine stops and calculate the temperature in the control module. Therefore, before starting service of the power steering system which requires disconnection of the connect ...