Subaru Crosstrek Service Manual: Installation

1. Install the O-ring to the input shaft.

NOTE:

• Use new O-rings.

• Apply CVTF to the O-ring.

2. While holding the torque converter assembly by hand, carefully install it into the torque converter case.

NOTE:

• Apply CVTF to the oil seal lip.

• Do not damage the oil seal and O-ring.

3. Engage the splines while gently rotating the torque converter assembly by hand, and securely insert the assembly.

4. Measure depth “A”, from converter case end surface to drive plate contacting surface.

Standard (reference):

6.8 mm (0.268 in) or less

5. Install the transmission assembly to the vehicle. Automatic Transmission Assembly > INSTALLATION">

Removal

Transfer clutch

Other materials:

Caution
GLASS/WINDOWS/MIRRORS > General DescriptionCAUTION• Before disassembling or reassembling parts, always disconnect the battery ground cable from battery. When replacing the audio, control module and other parts provided with memory functions, record the memory contents before disconnecting t ...

Installation
STARTING/CHARGING SYSTEMS(H4DO) > StarterINSTALLATIONInstall in the reverse order of removal.NOTE:• For CVT model, a nut is used at (a).• Tighten the starter and cable stay (b) together using the upper bolt securing the starter.Tightening torque:T1: 14 N·m (1.4 kgf-m, 10.3 ft-l ...

Inspection
SECURITY AND LOCKS > Door Lock Control SystemINSPECTION1. SYMPTOM CHARTSymptomsRepair orderReferenceThe door lock control system does not operate.1. Remove and visually inspect the following fuses.• No. 3 (in fuse & relay box)• No. 7 (in fuse & relay box)• No. 8 (in main ...