CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Pressure Sensor
INSTALLATION
CAUTION:
• Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.
• After installing the secondary pressure sensor, adjust the CVTF level.
Install in the reverse order of removal.
NOTE:
Use new O-rings.
Tightening torque:
39 N·m (4.0 kgf-m, 28.8 ft-lb)
Dtc p0974 shift solenoid "a" control circuit high
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0974 SHIFT SOLENOID "A" CONTROL CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:Gear is not changed. (No up-shift)CAUTION:Use the check boar ...
Component
SPEED CONTROL SYSTEMS(H4DO) > General DescriptionCOMPONENT(1)Accelerator pedal ASSY (sport type)(4)Accelerator plateTightening torque: N·m (kgf-m, ft-lb)(2)Accelerator pedal ASSY (normal type)(5)Accelerator stopperT:7.5 (0.8, 5.5)(3)Clip ...
Disassembly
BRAKE > Master CylinderDISASSEMBLY1. Remove the reservoir tank.CAUTION:Be careful not to tighten a vise excessively.(1) Place the master cylinder assembly between aluminum plates and fix it on a vise.(2) Drive out the pin using a punch and a hammer to remove the reservoir tank.2. Remove the seal ...