Subaru Crosstrek Service Manual: Installation

1. Install the reduction drive gear to secondary pulley.

2. Select the reduction drive gear shim. Reduction Drive Gear > ADJUSTMENT">

3. Install the dish plates, spring retainers, and selected reduction drive gear shims.

NOTE:

Install the dish plate in the correct direction.

4. Install the transmission case. Transmission Case > INSTALLATION">

5. Install the transmission control device. Transmission Control Device > INSTALLATION">

6. Install the oil strainer and oil pan. Oil Pan and Strainer > INSTALLATION">

7. Install the reduction driven gear assembly. Reduction Driven Gear > INSTALLATION">

8. Install the parking pawl. Parking Pawl > INSTALLATION">

9. Install the transfer driven gear assembly. Transfer Driven Gear > INSTALLATION">

10. Install the transfer clutch assembly. Transfer Clutch > INSTALLATION">

11. Install the extension case. Extension Case > INSTALLATION">

12. Install the inhibitor switch. Inhibitor Switch > INSTALLATION">

13. Install the secondary speed sensor. Secondary Speed Sensor > INSTALLATION">

14. Install the primary speed sensor. Primary Speed Sensor > INSTALLATION">

15. Install the turbine speed sensor. Turbine Speed Sensor > INSTALLATION">

16. Install the transmission harness. Transmission Harness > INSTALLATION">

17. Install the control valve body. Control Valve Body > INSTALLATION">

18. Install the air breather hose. Air Breather Hose > INSTALLATION">

19. Install the transmission assembly to the vehicle. Automatic Transmission Assembly > INSTALLATION">

Inspection

Reduction driven gear

Other materials:

Inspection mode Procedure
ENGINE (DIAGNOSTICS)(H4DO) > Inspection ModePROCEDUREPerform the diagnosis shown in the following DTC table.When performing the diagnosis not listed in “List of Diagnostic Trouble Code (DTC)”, refer to the item on the drive cycle. Drive Cycle">DTCItemConditionB1570ANTENNA — ...

Inspection
IGNITION(H4DO) > Spark PlugINSPECTION1. Check the spark plug for abnormalities. If defective, replace the spark plug.(A)Terminal damage(B)Crack or damage in insulator(C)Damaged gasket2. Check the spark plug electrode and condition of the insulator. If abnormal, check and repair the cause and repl ...

EyeSight (models with EyeSight system)
NOTE For models with the EyeSight system, refer to the Owner's Manual supplement for the EyeSight system. BSD/RCTA (if equipped) After entering the "BSD/RCTA" menu, select the "Warning Volume" menu. You can set the volume of the warning buzzer for RCTA (Rear Cross Traffic Alert). You can se ...