Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Installation

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed Sensor

INSTALLATION

CAUTION:

Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occurs, replace with a new part.

Install in the reverse order of removal.

NOTE:

• Use new O-rings.

• Apply CVTF to the O-ring.

Tightening torque:

7 N·m (0.7 kgf-m, 5.2 ft-lb)

Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed SensorREMOVALCAUTION:Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occurs, re ...

Reduction drive gear
...

Other materials:

Journey time
The journey time shows the time that has elapsed since the ignition switch was turned to the "ON" position. The journey time indication flashes each time a complete hour has elapsed. If the display is giving a reading other than the journey time, the display switches to the journey ti ...

Disassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyDISASSEMBLY1. Put vinyl tape around main shaft spline to protect the oil seal from damage. Then pull out the oil seal and needle bearing by hand.2. Remove the lock nut and lock washer.NOTE:Flatten the lock nut tab before removing the ...

Treadwear
The treadwear grade is a comparative rating based on the wear rate of the tire when tested under controlled conditions on a specified government test course. For example, a tire graded 150 would wear one and one-half (1- 1/2) times as well on the government course as a tire graded 100. ...

© 2016-2026 Copyright www.sucross.com