Subaru Crosstrek Service Manual: Installation

1. Install the O-ring.

NOTE:

• Use new O-rings.

• Apply CVTF to the O-ring.

2. Install the plate and the oil pump.

NOTE:

Apply CVTF to the bolt.

Tightening torque:

8.5 N·m (0.9 kgf-m, 6.3 ft-lb)

3. Install the oil pump chain cover. Oil Pump Chain > INSTALLATION">

4. Install the torque converter assembly. Torque Converter Assembly > INSTALLATION">

5. Install the transmission assembly to the vehicle. Automatic Transmission Assembly > INSTALLATION">

Removal

Oil pump chain

Other materials:

Voice command example: Dial number
1. Press the talk switch on the steering wheel. 2. Say "Dial number". 3. Say "Dial <number>". For example, if the phone number is 2345678: Say "two three four five six seven eight" Do not say "twenty three forty five sixty seven eight" 4. Say"Dial" or press the off hook switch ...

Preparation tool
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select ...

Dtc p0961 pressure control solenoid "a" control circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0961 PRESSURE CONTROL SOLENOID "A" CONTROL CIRCUIT RANGE/PERFORMANCEDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Acceleration is poor during ...