Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Installation

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Inhibitor Switch

INSTALLATION

1. Install the inhibitor switch to the transmission case temporarily.

2. Connect the inhibitor harness connector to the inhibitor switch.

3. Install the shifter arm and fix with the spring pin.

NOTE:

Use new spring pin.

(A)

Spring pin

(B)

Shifter arm

4. Shift the shifter arm to “N” range.

5. Install the ST vertically in the cutout of shifter arm and the hole of switch body.

ST 499267300STOPPER PIN

6. Tighten the two bolts holding the inhibitor switch.

Tightening torque:

5 N·m (0.5 kgf-m, 3.7 ft-lb)

7. Install the select cable to the shifter arm.

8. Install the washer and snap pin to the shifter arm.

CAUTION:

Do not apply extra overload while holding the part (A).

(A)

Shifter arm

(B)

Snap pin

(C)

Select cable

(D)

Washer

9. Install the center exhaust pipe. Center Exhaust Pipe > INSTALLATION">

10. Lower the vehicle.

11. Connect the battery ground terminal.

12. Check the inhibitor switch. Inhibitor Switch > INSPECTION">

Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Inhibitor SwitchINSPECTIONWhen the driving condition or starter motor operation is improper, first check the shift linkage for improper operation. If the ...

Oil pan and strainer
...

Other materials:

Inspection
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunroof MotorINSPECTIONCheck the auto-reverse mechanism.CAUTION:Do not place objects in the way to check the auto-reverse mechanism.1. Open the lid assembly - sunroof.2. Push the lid assembly - sunroof in the opening direction with a force of 110±10 N (1 ...

List
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Code(s) DisplayLISTDTCItemNoteU0073CONTROL MODULE COMMUNICATION BUS OFF Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0073 CONTROL MODULE COMMUNICATION BUS OFF">U0100LOST COMMUNICATION WITH ECM/PCM “A” Diagnostic ...

Removal
EXTERIOR/INTERIOR TRIM > Rear Gate GarnishREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL">3. Remove the arm assembly - rear wiper.(1) Remove the cover - rear wiper arm.(2) Remove the nut, and remove the ...

© 2016-2025 Copyright www.sucross.com