Subaru Crosstrek Service Manual: Installation

1. Temporarily install the drive plate and reinforcement drive plate.

NOTE:

Align the knock pin hole of the crankshaft position sensor plate to the knock pin of the crankshaft to secure the knock pin.

2. Set the ST.

3. Tighten the drive plate mounting bolt in two stages.

(1) Tighten the drive plate mounting bolt.

Tightening torque:

30 N·m (3.1 kgf-m, 22.1 ft-lb)

(2) While checking the tightening angle with the angle gauge, tighten the drive plate mounting bolts to the specified angle.

Tightening angle:

30° — 35°

4. Install the transmission assembly to the vehicle. Automatic Transmission Assembly > INSTALLATION">

Removal

Extension case

Other materials:

Dtc c2324 transmitter 4 function code abnormal
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2324 TRANSMITTER 4 FUNCTION CODE ABNORMALDetected when error data is received from each transmitter at a vehicle speed of 40 km/h (25 MPH) or more.DTC DETECTING CONDITION:Unexpected functio ...

Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Tumble Generator Valve AssemblyINSPECTION1. CHECK MOTOR1. Connect the battery positive terminal to terminal No. 5 and the battery ground terminal to terminal No. 4, and check that the valve is fully opened on LH side and the valve is fully closed on RH side.C ...

Disassembly
BRAKE > Rear Disc Brake AssemblyDISASSEMBLYCAUTION:Be careful not to allow foreign matter to enter the brake hose connector.1. Remove mud and foreign matter from the caliper body assembly.2. Remove the piston boot from caliper body cylinder.3. Remove the piston - disc brake.(1) Place a wooden blo ...