Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Installation

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Drive Pinion Shaft Assembly

INSTALLATION

1. Clean the mating surface of drive pinion retainer and converter case.

2. Adjust the backlash and tooth contact between drive pinion shaft assembly and the front differential side gear. Drive Pinion Shaft Assembly > ADJUSTMENT">

3. Install O-rings in two locations to the converter case.

NOTE:

Use new O-rings.

Apply CVTF to the O-ring.

4. Apply liquid gasket seamlessly to the mating surface of drive pinion retainer.

Liquid gasket:

THREE BOND 1215B or equivalent

5. Install the drive pinion retainer to converter case, and tighten the bolt using the ST.

ST 18270KA020SOCKET (E20)

NOTE:

Do not confuse the three different-length bolts when installing.

Tightening torque:

43 N·m (4.4 kgf-m, 31.7 ft-lb)

6. Install the forward clutch assembly. Forward Clutch Assembly > INSTALLATION">

7. Install the reverse brake assembly. Reverse Brake Assembly > INSTALLATION">

8. Install the primary pulley, secondary pulley and variator chain. Primary Pulley and Secondary Pulley > INSTALLATION">

9. Install the reduction drive gear. Reduction Drive Gear > INSTALLATION">

10. Install the transmission case. Transmission Case > INSTALLATION">

11. Install the transmission control device. Transmission Control Device > INSTALLATION">

12. Install the oil strainer and oil pan. Oil Pan and Strainer > INSTALLATION">

13. Install the reduction driven gear assembly. Reduction Driven Gear > INSTALLATION">

14. Install the transfer driven gear assembly. Transfer Driven Gear > INSTALLATION">

15. Install the transfer clutch assembly. Transfer Clutch > INSTALLATION">

16. Install the parking pawl. Parking Pawl > INSTALLATION">

17. Install the extension case. Extension Case > INSTALLATION">

18. Install the inhibitor switch. Inhibitor Switch > INSTALLATION">

19. Install the secondary speed sensor. Secondary Speed Sensor > INSTALLATION">

20. Install the primary speed sensor. Primary Speed Sensor > INSTALLATION">

21. Install the turbine speed sensor. Turbine Speed Sensor > INSTALLATION">

22. Install the transmission harness. Transmission Harness > INSTALLATION">

23. Install the control valve body. Control Valve Body > INSTALLATION">

24. Install the air breather hose. Air Breather Hose > INSTALLATION">

25. Install the transmission assembly to the vehicle. Automatic Transmission Assembly > INSTALLATION">

Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Drive Pinion Shaft AssemblyINSPECTION• Make sure that all component parts are free of scratches, holes and other faults.• Check the tooth con ...

Drive plate
...

Other materials:

Before using aha application
In order to use the aha application on this system, the application must be installed on the smartphone. Settings required to use aha application Search and download the aha application from your smartphone app store. iPhone and iPod touch: Apple App Store via iTunes Android device ...

Installation
DRIVE SHAFT SYSTEM > Front Hub Unit BearingINSTALLATION1. Place the front brake back plate between the front axle housing and the front hub unit bearing, and tighten the bolt.CAUTION:• Do not get closer the tool which charged magnetism to magnetic encoder.• Be careful not to damage th ...

Dtc b1833 short in curtain shield airbag rh squib circuit (to +b)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1833 SHORT IN CURTAIN SHIELD AIRBAG RH SQUIB CIRCUIT (TO +B)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Curtain airbag harness (RH) is shorted to power supply.• Curtain airbag ...

© 2016-2022 Copyright www.sucross.com