Subaru Crosstrek Service Manual: Installation

1. Install the CVTF cooler (with warmer feature) to the transmission.

Tightening torque:

23 N·m (2.3 kgf-m, 17.0 ft-lb)

2. Install the engine coolant inlet hose.

NOTE:

With the triangle mark on the engine coolant inlet hose facing the vehicle outside, install the hose to the EGR cooler.

3. Install the CVTF inlet hose and CVTF outlet hose to transmission.

NOTE:

Use the new CVTF inlet hose and CVTF outlet hose.

4. Connect the engine coolant outlet hose.

5. Check installation condition of each hose.

• Make sure the hoses do not interfere with each other or with other components.

• Check each hose for bent, excess curve, and twisting conditions.

6. Install the engine hanger rear.

Tightening torque:

21 N·m (2.1 kgf-m, 15.5 ft-lb)

7. Connect the EGR control valve harness connector, throttle position sensor harness connector and manifold absolute pressure sensor harness connector.

8. Connect the engine harness connectors, then install the harness connector bracket.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

9. Install the air intake boot assembly. Air Intake Boot > INSTALLATION">

10. Connect the battery ground terminal.

11. Fill engine coolant. Engine Coolant > REPLACEMENT">

12. Adjust the CVTF level. CVTF > ADJUSTMENT">

Inspection

Cvtf filter

Other materials:

Dtc u0423 invalid data received from instrument panel cluster control module
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0423 INVALID DATA RECEIVED FROM INSTRUMENT PANEL CLUSTER CONTROL MODULEReceived error data from combination meter.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic ...

Remote transmitter program (models without "keyless access with push-button start system")
New transmitters can be programmed to the remote engine start system in the event that a transmitter is lost, stolen, damaged or additional transmitters are desired (the system will accept up to eight transmitters). New remote engine start transmitters can be programmed accord-ing to the follo ...

Keyless buzzer volume setting
1. Perform the preparation steps according to "Preparation for car settings" 2. Operate the "  " or " " switch to select the "Keyless Buzzer Volume" item. Then push the  button. 3. Select a volume level by operating the "  " or "  " switch, and confirm the set ...