CLUTCH SYSTEM > Release Bearing and Lever
INSTALLATION
NOTE:
Apply the specified grease to lubricate to the following points before installation.
• Contact surface of lever and pivot
• Contact surface of lever and bearing
• Transmission main shaft spline
• Contact surface of release bearing and transmission case
Grease
NICHIMOLY N-130 or equivalent
1. While pushing the release lever to the pivot and twisting it to both sides, fit the lever spring onto the raised portion of the pivot.
NOTE:
Observing from the main case hole, check that the lever spring is installed securely.
(A) | Release lever |
2. Install the release bearing and fasten it with two clips.
3. Install the dust cover.
(A) | Release lever |
(B) | Dust cover |
4. Operate the release lever and check if the release bearing moves smoothly.
5. Apply grease to the contact point of the release lever and operating cylinder.
Grease
NICHIMOLY N-130 or equivalent
6. Install the transmission assembly. Manual Transmission Assembly > INSTALLATION">
Removal
AIRBAG SYSTEM > Satellite Safing SensorREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Turn the ignition switch to OFF.2. Disconnect the g ...
Inspection
AIRBAG SYSTEM > Roll ConnectorINSPECTION1. VISUAL INSPECTIONCheck for the following, and replace the damaged parts with new parts.• Combination switch is cracked or deformed.• Roll connector is cracked or deformed.2. UNIT INSPECTION OF ROLL CONNECTORCAUTION:• Do not rotate the r ...
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Heater Vent DuctINSTALLATIONCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">Install each part in the reve ...