CLUTCH SYSTEM > Master Cylinder
INSTALLATION
1. Install the master cylinder to the body, and connect the clutch pipe and the tank hose.
Tightening torque:
T1: 15 N·m (1.5 kgf-m, 11.1 ft-lb)
T2: 18 N·m (1.8 kgf-m, 13.3 ft-lb)
2. Connect the push rod of the master cylinder, and install the clevis pin and snap pin.
CAUTION:
Always use a new clevis pin.
NOTE:
Apply grease to the clevis pin.
(A) | Clevis pin |
(B) | Snap pin |
(C) | Push rod |
3. Install the knee airbag module. Knee Airbag Module > INSTALLATION">
4. Fill the recommended brake fluid. Clutch Fluid">
5. After bleeding air from the clutch system, ensure that the clutch operates properly. Clutch Fluid Air Bleeding">
6. Install the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > INSTALLATION">
7. Install the air intake boot. Air Intake Boot > INSTALLATION">
8. Connect the battery ground terminal.
Installation
SECURITY AND LOCKS > Body Integrated UnitINSTALLATIONCAUTION:• When the control module related to immobilizer has been replaced, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to “Type B” described in “REGISTRATION MANUAL ...
Adjustment
SECURITY AND LOCKS > Impact SensorADJUSTMENT1. CHECK IMPACT SENSOR1. Pull out the key from the ignition switch, or turn the ignition switch to OFF.2. Close all the windows.3. Close all the doors and rear gate. Leave open the front hood.4. Press the LOCK button of the keyless transmitter or access ...
Rear towing hook
1. Take the towing hook and screwdriver
out of the tool bucket. Take the jack
handle out of the cargo area.
2. Pry off the cover on the rear bumper
using a screwdriver, and you will find a
threaded hole for attaching the towing
hook.
3. Screw the towing hook into the thread
hole unti ...