Subaru Crosstrek Service Manual: Installation

1. Press in a new pilot bearing to the position where it is flush with the flywheel surface or up to 0.4 mm (0.016 in) deeper than that.

CAUTION:

Do not press the bearing inner ring.

2. Temporarily tighten the crankshaft position sensor plate and flywheel.

NOTE:

Align the knock pin hole of the crankshaft position sensor plate to the knock pin of the crankshaft to secure the knock pin.

3. Attach the ST.

4. Tighten the flywheel mounting bolts in two stages.

(1) Tighten the flywheel attachment bolts.

Tightening torque:

30 N·m (3.1 kgf-m, 22.1 ft-lb)

(2) While checking the tightening angle with the angle gauge, further tighten the flywheel mounting bolts.

Tightening angle:

30° — 35°

5. Install the clutch disc and clutch cover. Clutch Disc and Cover > INSTALLATION">

6. Install the transmission assembly. Manual Transmission Assembly > INSTALLATION">

Removal

General description

Other materials:

Moonroof (if equipped)
WARNING Never let anyone's hands, arms, head or any objects protrude from the moonroof. A person could be seriously injured if any of the following conditions occur. The vehicle stops suddenly. The vehicle turns sharply. The vehicle is involved in an accident. Body parts protruding ...

Dtc p0111 intake air temperature sensor 1 circuit range/performance bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0111 INTAKE AIR TEMPERATURE SENSOR 1 CIRCUIT RANGE/PERFORMANCE BANK 1DTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Improper idling• Poor d ...

System block diagram
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Control Module I/O SignalSYSTEM BLOCK DIAGRAM• Blind Spot Detection/Rear Cross Traffic Alert system consists of the following.• There is a control ECM in the radar sensor main body, which performs the vehicle identification ...