Subaru Crosstrek Service Manual: Installation
CLUTCH SYSTEM > Clutch Pipe and Hose
INSTALLATION
Install in the reverse order of removal.
NOTE:
Bleed air from brake fluid. Clutch Fluid Air Bleeding">
Tightening torque:
T1: 15 N·m (1.5 kgf-m, 11.1 ft-lb)
T2: 18 N·m (1.8 kgf-m, 13.3 ft-lb)
T3: 25 N·m (2.5 kgf-m, 18.4 ft-lb)
(A) | Clutch pipe |
(B) | Clamp |
(C) | Clutch hose |
(D) | Tank hose |
Tightening torque:
Air intake boot
3 N·m (0.3 kgf-m, 2.2 ft-lb)
Removal
CLUTCH SYSTEM > Clutch Pipe and HoseREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) connecting the air intake boot and air ...
Clutch switch
...
Other materials:
Preparation tool
DIFFERENTIALS > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS398477701HANDLE• Used for installing the rear bearing race.• Used for installing the front bearing race.398477702DRIFT• Used for installing the front bearing race. (T-type) ...
Removal
EXTERIOR/INTERIOR TRIM > Floor MatREMOVALCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Airbag system satellite safing sensor is lo ...
Removal
EXTERIOR/INTERIOR TRIM > Rear BumperREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear combination ...
