Subaru Crosstrek Service Manual: Installation
CLUTCH SYSTEM > Clutch Pedal
INSTALLATION
1. Install in the reverse order of removal.
CAUTION:
Always use a new clevis pin.
Tightening torque:
Clutch pedal
18 N·m (1.8 kgf-m, 13.3 ft-lb)
Knee airbag module
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Air intake boot
3 N·m (0.3 kgf-m, 2.2 ft-lb)
2. Adjust the clutch pedal after installation. Clutch Pedal > ADJUSTMENT">
3. Check the clutch start system.
Inspection
CLUTCH SYSTEM > Clutch PedalINSPECTIONMove the clutch pedal pads in the lateral direction with a force of approximately 10 N (1 kgf, 2 lbf) to check that the clutch pedal deflection is within the s ...
Other materials:
Dtc c1251 wheel speed sensor system
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1251 WHEEL SPEED SENSOR SYSTEMNOTE:For the diagnostic procedure, refer to “DTC C1241 REAR LEFT ABS SENSOR CIRCUIT”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > ...
Preparation tool
SECURITY AND LOCKS > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor 4, refer to &ldqu ...
Disarming the system
Perform either of the following procedures.
Briefly press the disarm button (for less
than 2 seconds) on the access key/remote
transmitter.
Carry the access key and perform
either of the following procedures (models
with "keyless access with push-button
start system").
Grip the front door ...