Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Installation

BRAKE > Rear Brake Pad

INSTALLATION

NOTE:

Before installation, remove mud and foreign matter from the caliper body assembly and support - rear disc brake.

1. Before installation, check the brake pad. Rear Brake Pad > INSPECTION">

2. Apply a thin coat of grease to the pad clip.

Preparation items:

Grease: An item contained in the pad kit or equivalent

3. Apply a thin coat of grease to the shim - disc brake rear inner (a) and the shim - disc brake rear outer (b).

Preparation items:

Grease: Those contained in the pad kit or WAKO grease V160

(A)

Pad - disc brake rear outer

(B)

Pad - disc brake rear inner

4. Install the brake pad to the support - rear disc brake.

5. Install the caliper body assembly to the support - rear disc brake.

Tightening torque:

Caliper bolt: 27 N·m (2.75 kgf-m, 19.9 ft-lb)

6. Install the brake hose bracket.

Tightening torque:

Brake hose bracket: 33 N·m (3.36 kgf-m, 24.3 ft-lb)

7. Install the rear wheels.

Tightening torque:

Except for C4 model: 120 N·m (12.24 kgf-m, 88.5 ft-lb)

C4 model: 100 N·m (10.20 kgf-m, 73.8 ft-lb)

Removal
BRAKE > Rear Brake PadREMOVAL1. Lift up the vehicle, and then remove the rear wheels.2. Remove the rear brake pad.(1) Remove the bolts and remove the brake hose bracket.(2) Remove the caliper bolt, ...

Rear disc brake assembly
...

Other materials:

Installation
LIGHTING SYSTEM > Turn Signal Light & Hazard Light UnitINSTALLATIONCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">Install each part in the reve ...

Brake warning light does not go off
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Warning Light Illumination PatternBRAKE WARNING LIGHT DOES NOT GO OFFDetecting condition:• Brake warning light circuit is shorted.• Defective sensor/connector• Defective CAN communicationTrouble symptom:After starting the engine, th ...

Installation
LIGHTING SYSTEM > Headlight BulbINSTALLATIONCAUTION:Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a).1. Install each part in the reverse order of removal.2. When performi ...

© 2016-2025 Copyright www.sucross.com