BRAKE > Master Cylinder
INSTALLATION
1. Replace the seal sub assembly for the master cylinder assembly with a new part.
CAUTION:
Be careful not to install the seal sub assembly in the wrong location.
(a) | Primary piston | (b) | Seal sub ASSY | (c) | Install the seal sub assembly to this surface. |
2. Install each part in the reverse order of removal.
Tightening torque:
Master cylinder assembly: 13 N·m (1.33 kgf-m, 9.6 ft-lb)
Brake pipe flare nut: 19 N·m (1.94 kgf-m, 14.0 ft-lb)
3. Bleed air from the brake system. Air Bleeding > PROCEDURE">
Low fuel warning light
The
low fuel warning light illuminates
when the tank is nearly empty, at approximately
2.6 US gal (10.0 liters, 2.2 Imp gal).
It only operates when the ignition switch is
in the "ON" position.
CAUTION
Promptly put fuel in the tank whenever
the low fuel warning light
illuminates. Engine ...
Washing
CAUTION
When washing the vehicle, the
brakes may get wet. As a result,
the brake stopping distance will
be longer. To dry the brakes,
drive the vehicle at a safe speed
while lightly depressing the
brake pedal to heat up the
brakes.
Do not wash the engine compartment
and area ad ...
Harness components location Location
WIRING SYSTEM > Harness Components LocationLOCATION(1)Front wiring harness(7)Rear wiring harness RH(12)Front door cord LH(2)Engine wiring harness(8)Rear wiring harness LH(13)Transmission cord(3)Bulkhead wiring harness(9)Roof cord(14)Generator cord(4)Instrument panel wiring harness(10)Rear gate co ...