Subaru Crosstrek Service Manual: Installation
BRAKE > Brake Pipe
INSTALLATION
CAUTION:
• Be careful of the following items. Failure to do so may cause the airbag system malfunction.
– Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuits, follow the cautions of “AIRBAG SYSTEM”. General Description > CAUTION">
– Be careful not to damage the airbag system wiring harness when servicing the electrical parts around the steering column.
• Be careful not to damage the airbag system wiring harness when servicing the center brake pipe.
• When removing the brake pipe, do not bend.
• After installing the brake pipe and hose, perform air bleed.
• After installing the brake hoses, make sure that they do not contact the tires or suspension assembly, etc.
NOTE:
The airbag system wiring harness is routed near the center brake pipe.
Tightening torque:
Front brake pipes & hoses: General Description > COMPONENT">
Center & rear brake pipes and hoses: General Description > COMPONENT">
Removal
BRAKE > Brake PipeREMOVALCAUTION:• Be careful of the following items. Failure to do so may cause the airbag system malfunction.– Yellow connectors and harnesses with yellow tapes around th ...
Front brake pad
...
Other materials:
Subaru select monitor Operation
IMMOBILIZER (DIAGNOSTICS) > Subaru Select MonitorOPERATION1. HOW TO USE THE SUBARU SELECT MONITORFor detailed operation procedures, refer to “Application help”.2. READ DIAGNOSTIC TROUBLE CODE (DTC) FOR ENGINE AND BODY INTEGRATED UNITRefer to “Read Diagnostic Trouble Code (DTC)&r ...
Clear memory mode Operation
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» displa ...
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Oil Control SolenoidINSPECTION1. Check that the oil control solenoid has no deformation, cracks or other damages.2. Measure the resistance between the oil control solenoid terminals.Terminal No.Standard1 and 27.25±0.4 ? (when 20°C (68°F ...
