Subaru Crosstrek Service Manual: Installation

1. FRONT BRAKE HOSE

1. Secure the brake hose to strut mount.

Tightening torque:

Brake hose: 33 N·m (3.36 kgf-m, 24.3 ft-lb)

2. Connect the brake hose to the front caliper body assembly using a new gasket.

Tightening torque:

Union bolt: 26 N·m (2.65 kgf-m, 19.2 ft-lb)

3. Position the disc in straight position and route the brake hose through the hole in the bracket on the wheel apron side.

CAUTION:

Do not twist the brake hose.

4. Temporarily tighten the flare nut which connects brake pipe and hose.

5. Secure the brake hose to wheel apron bracket with clamp.

6. Tighten the flare nut to the specified torque.

Tightening torque:

Brake pipe flare nut: 15 N·m (1.53 kgf-m, 11.1 ft-lb)

7. Bleed air from the brake system. Air Bleeding > PROCEDURE">

1. Route the brake hose through the hole of bracket, and lightly tighten the flare nut to connect brake pipe.

2. Insert the clamp to secure brake hose.

Tightening torque:

Brake hose bracket: 33 N·m (3.36 kgf-m, 24.3 ft-lb)

3. Install the brake hose to rear caliper body using a new gasket.

Tightening torque:

Union bolt: 26 N·m (2.65 kgf-m, 19.2 ft-lb)

4. Tighten the flare nut to the specified torque.

Tightening torque:

Brake pipe flare nut: 15 N·m (1.53 kgf-m, 11.1 ft-lb)

5. Bleed air from the brake system. Air Bleeding > PROCEDURE">

Removal

Brake pedal

Other materials:

Door cord Location
WIRING SYSTEM > Door CordLOCATIONConnectorConnecting toNo.PoleColorAreaNo.DescriptionD18BlackC-2B30Bulkhead wiring harnessD22C-4 Front door speaker LHD36Dark grayC-4 Front power window motor LHD510B-4 Outer mirror assembly LHD716B-4 Power window main switchD118BlackC-4B101Bulkhead wiring harnessD ...

Control screen and audio panel
Select to display the audio source selection screen. Select to display the play mode currently selected. Refer to "Select play mode" Select to display as a list (for the models with AVRCP Ver. 1.4 or higher). The track pauses when touched during playback and plays when touched ...

Steering warning light does not go off
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > STEERING Warning LightSTEERING WARNING LIGHT DOES NOT GO OFFDetecting condition:• Defective combination meter• Open circuit of harnessTrouble symptom:When starting the engine, the STEERING warning light continues to illuminate.STE ...