Subaru Crosstrek Service Manual: Inspection mode Procedure
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Inspection Mode
PROCEDURE
Road Test">
Electrical component location Location
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Electrical Component LocationLOCATION1. CONTROL MODULE(1)Transmission control module (TCM)(3)AWD light(5)Body integrated unit(2)AT OIL TEMP light( ...
List of diagnostic trouble code (dtc) List
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > List of Diagnostic Trouble Code (DTC)LISTDTCItemContent of diagnosisReferenceP0500VEHICLE SPEED SENSOR "A" CIRCUITWheel speed data from ...
Other materials:
Caution
DRIVE SHAFT SYSTEM > General DescriptionCAUTION• When performing any work, always wear work clothes, a work cap and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.• Remove contamination including dirt and corrosion before removal, installation, di ...
Rear combination lights
1. Using a Phillips screwdriver, remove
the upper and lower screws that secure
the rear combination light assembly.
2. Slide the rear combination light as-
11-38
sembly rearward and remove it from the
vehicle.
Rear side marker light
Rear turn signal light
Backup light
Sto ...
To increase the speed (by accelerator pedal)
1. Depress the accelerator pedal to
accelerate the vehicle to the desired
speed.
2. Press the "RES/SET" switch to the
"SET" side once. Now the desired speed
is set and the vehicle will keep running at
that speed without depressing the accelerator
pedal.
NOTE
U.S.-spec. models
If t ...
