WIPER AND WASHER SYSTEMS > Wiper Blade
INSPECTION
1. Check and clean the rubber assembly - wiper.
CAUTION:
• Do not use organic solvent-based cleaner when cleaning rubber parts in order to avoid rubber part deterioration.
• Clean rubber parts using a soft cloth or paper towel dampened with windshield washer fluid or mild synthetic detergent.
Replace the rubber assembly - wiper if rubber part hardening, deformation or damage is found.
2. Operate the washer system to check if a chattering sound or insufficient wiping occurs.
3. If a chattering sound or insufficient wiping occurs, perform the following procedures.
(1) Make sure that the blade assembly - wiper is not deformed and the movable part moves smoothly.
(2) Remove oil film and dirt from the glass.
CAUTION:
• When powder-type glass cleaner is used, use after having been dissolved in water sufficiently. If it is used in less water, the glass surface may be damaged.
• Clean the glass surface using a soft cloth or sponge with glass cleaner.
(3) Operate the windshield wiper again. If a chattering sound or insufficient wiping occurs, perform the procedures again.
4. If defective is not improved after performing step 1) to step 3), replace the rubber assembly - wiper with a new part.
Dtc p2004 tgv control stuck open bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2004 TGV CONTROL STUCK OPEN BANK 1DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION"&g ...
Dtc b2786 steering lock cm communication
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2786 STEERING LOCK CM COMMUNICATIONDTC detecting condition:When communication between keyless access CM and steering lock CM is interrupted for a set amount of time.Trouble sym ...
Installation
INTAKE (INDUCTION)(H4DO) > Air Cleaner CaseINSTALLATION1. Install the bolt (A) and nut (B) which secure the air cleaner case (front) to the body.Tightening torque:Bolt (A)6 N·m (0.6 kgf-m, 4.4 ft-lb)Nut (B)7.5 N·m (0.8 kgf-m, 5.5 ft-lb)2. Install the air cleaner case (rear) and air ...