WIPER AND WASHER SYSTEMS > Wiper and Washer System
INSPECTION
Symptoms | Repair order |
Wiper and washers do not operate. |
(1) Wiper fuse (F/B No. 14, 15)
(2) Combination switch
(3) Motor assembly - wiper
(4) Wiring harness
Wipers do not operate in LO or HI.
(1) Combination switch
(2) Motor assembly - wiper
(3) Wiring harness
Wipers do not operate in INT.
(1) Combination switch
(2) Motor assembly - wiper
(3) Wiring harness
Washer motor does not operate.
(1) Combination switch
(2) Motor pump assembly - washer
(3) Wiring harness
Wipers do not operate when washer switch is ON.
(1) Motor assembly - wiper
(2) Wiring harness
Washer fluid spray does not operate properly.
(1) Motor pump assembly - washer
(2) Hose assembly - washer
(3) Nozzle - washer
Wiper chatters or judders during operation.
(1) Oil film and dirt on the glass
(2) Arm assembly windshield wiper
(3) Motor assembly - wiper
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Sub Level SensorINSPECTION1. Check that the fuel sub level sensor has no damage.2. Measure the fuel sub level sensor float position.(1)FULL(2)EMPTY(3)Datum pointsFloat positionStandardFULL to Datum point (A)5.31±3.5 mm (0.209±0.138 in)EMPTY to Datum po ...
Removal
MECHANICAL(H4DO) > CamshaftREMOVAL1. CAMSHAFT RHThe camshaft RH and cam carrier are designed as removing as a unit. Refer to “Cam Carrier” for removal procedures of camshaft RH. Cam Carrier > REMOVAL"> Cam Carrier > DISASSEMBLY">2. CAMSHAFT LHThe camshaft LH an ...
Inspection
SECURITY AND LOCKS > Security SystemINSPECTION1. BASIC DIAGNOSTIC PROCEDURESTEPCHECKYESNO1.INITIAL CHECK.Check the keyless entry system or keyless access system operation.Does the keyless entry system or keyless access system operate normally? Security System > INSPECTION">Go to Step 2 ...