WIPER AND WASHER SYSTEMS > Washer Tank and Motor
INSPECTION
1. WASHER PUMP
Apply battery voltage to the connector terminal of the motor pump assembly - washer, and make sure that the motor operates.
2. WASHER FLUID LEVEL SENSOR
1. Check the connection status of washer fluid level sensor connector.
2. Does the low washer fluid warning light illuminate after draining the washer fluid? And does the low washer fluid warning light go off after refilling the washer fluid?
• Yes > Normal operation.
• No > Perform step 3.
3. Using a tester, measure the voltage of the washer fluid level sensor connector.
(1) Is the voltage approx. 8.5 V or more?
• Yes > Perform step 4.
• No > Check harness, meter and integrated unit, and replace if necessary.
4. Does the meter indicator illuminate if you short the washer fluid level sensor connector?
• Yes > Perform step 5.
• No > Check meter and integrated unit, and replace if necessary.
5. Using a tester, measure the resistance of the washer fluid level sensor.
(1) Turn over the mud guard.
(2) Measure the resistance of the washer fluid level sensor.
Amount of washer fluid in the tank | Standard |
No remaining quantity (ON) | Less than 10 ? |
There is remaining quantity (OFF) | 1 M? or more |
(3) Is the resistance within the standard?
• Yes > Normal operation.
• No > Replace the washer fluid level sensor along with the washer tank.
Clutch fluid air bleeding Procedure
CLUTCH SYSTEM > Clutch Fluid Air BleedingPROCEDURECAUTION:Be careful not to spill the brake fluid. Brake fluid spilled on the vehicle body will harm the paint surface; wash it off with water and wipe clean quickly if spilled.NOTE:Bleed air from the oil line with help of a co-worker.1. Remove the ...
Removal
LIGHTING SYSTEM > Front Fog Light AssemblyREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the screw and clips, and turn over the front side of the mud guard - front.4. From the bottom of the bumper face - front, remove the fog light assembly - f ...
Turn signal lever
To activate the right turn signal, push the
turn signal lever up. To activate the left
turn signal, push the turn signal lever
down. When the turn is finished, the lever
will return automatically. If the lever does
not return after cornering, return the lever
to the neutral position by han ...