Subaru Crosstrek Service Manual: Inspection
WIPER AND WASHER SYSTEMS > Rear Wiper Motor
INSPECTION
CAUTION:
Fix the motor to prevent the motor from being shorted by moving during operation.
1. Connect the battery to the motor assembly - rear wiper connector, and check that the motor assembly - rear wiper operates.
2. Connect the battery to terminals of the connector, and remove the terminal connection with motor rotating, and stop the motor in mid-operation.
3. Connect the battery and check that the motor stops at the automatic stop position after the motor operates at low speed again.
Rear wiper motor
...
Removal
WIPER AND WASHER SYSTEMS > Rear Wiper MotorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL">3. Remove t ...
Other materials:
Talking on the phone
The call screen opens when you perform
the following operations.
When you accept a call on the incoming
call screen (by selecting the
key),
the call screen opens.
When you are on the outgoing call
screen, the screen changes to the call
screen when the other party answers the ...
Dtc b1833 short in curtain shield airbag rh squib circuit (to +b)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1833 SHORT IN CURTAIN SHIELD AIRBAG RH SQUIB CIRCUIT (TO +B)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Curtain airbag harness (RH) is shorted to power supply.• Curtain airbag ...
Dtc b1610 front sub sensor rh failure
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1610 FRONT SUB SENSOR RH FAILUREDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Front sub sensor (RH) is faulty.If DTC B1610 is displayed, the circuit within the front sub sensor (RH) is faulty ...
