WIPER AND WASHER SYSTEMS > Rear Washer
INSPECTION
1. VISUAL INSPECTION
Check for the following items, and if any malfunction is found, replace the corresponding part.
• Make sure the nozzle - rear washer and the hose - rear washer are not clogged.
• Make sure the hose - rear washer is not bent.
2. INSPECTING THE SPRAY POSITION
1. Turn the wiper switch to OFF position.
2. While the vehicle is stopped, check that the washer spray position is as shown in the figure.
3. After inspection, if the spray position is significantly out of the specified range, replace the nozzle - rear washer with a new part.
Removal
BRAKE > Stop Light SwitchREMOVALCAUTION:Before handling the airbag system components, always refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from battery and wait for at l ...
Removal
INTAKE (INDUCTION)(H4DO) > Air Cleaner ElementREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the air intake duct. Air Intake Duct > REMOVAL">3. Disconnect the connector (A) from the mass air flow and intake air temperature sensor, and remove the clip (B). ...
Diagnostics chart for security indicator light Inspection
IMMOBILIZER (DIAGNOSTICS) > Diagnostics Chart for Security Indicator LightINSPECTION1. CHECK SECURITY INDICATOR LIGHT CIRCUITCAUTION:When the body integrated unit is replaced, registration of the immobilizer system is required. For details, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER& ...