Subaru Crosstrek Service Manual: Inspection

1. CHECK WITH SUBARU SELECT MONITOR

1. Connect the Subaru Select Monitor.

NOTE:

For detailed operation procedures, refer to “Application help”.

(1) On «Start» display, select «Diagnosis».

(2) On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

(3) On «Main Menu» display, select «Each System».

(4) On «Select System» display, select «Brake Control System» and select «Enter».

(5) On «Select Function» display, select «Data Monitor».

(6) From the data monitor item list, select «RR Wheel Speed» and «RL Wheel Speed».

2. Check if the speed indicated on the display changes in the same manner as the speedometer reading during acceleration/deceleration when the steering wheel is in the straight-ahead position.

3. If the speed indicated on the display does not change in the inspection, check the ABS wheel speed sensor. Front ABS Wheel Speed Sensor > INSPECTION">

1. Visually check the tip of the ABS wheel speed sensor for foreign particles or damage. If necessary, clean the tip or replace the ABS wheel speed sensor.

2. Disconnect the ABS wheel speed sensor connector.

3. Check the ABS wheel speed sensor cable for discontinuity. If defective, replace the ABS wheel speed sensor.

4. Connect a 12 V power supply to No. 1 terminal of ABS wheel speed sensor connector, then attach resistance to the No. 2 terminal. Rotate the wheel at about 2.75 km/h (2 MPH), and measure the voltage using an oscilloscope.

Standard value of output voltage:

0.7 — 1.4 V

5. Replace the ABS wheel speed sensor if the inspection result is not within the standard value.

Rear abs wheel speed sensor

Removal

Other materials:

Operation
INSTRUMENTATION/DRIVER INFO > Combination Meter SystemOPERATION1. SELF-DIAGNOSIS DISPLAY MODEThe self-diagnosis (checking of each meter, warning light, indicator light, illumination, LCD/TFT) of combination meter can be performed in the following procedure.1. ProcedureCAUTION:Perform the steps de ...

Tachometer
The tachometer shows the engine speed in thousands of revolutions per minute. CAUTION Do not operate the engine with the pointer of the tachometer in the red zone. In this range, fuel injection will be cut by the engine control module to protect the engine from overrevving. The engine will ...

Operation
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Read Current DataOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» ...