Subaru Crosstrek Service Manual: Inspection

1. CHECK WITH SUBARU SELECT MONITOR

1. Connect the Subaru Select Monitor to data link connector.

NOTE:

For detailed operation procedures, refer to “Application help”.

(1) On «Start» display, select «Diagnosis».

(2) On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

(3) On «Main Menu» display, select «Each System».

(4) On «Select System» display, select «Brake Control System» and select «Enter».

(5) On «Select Function» display, select «Data Monitor».

(6) From the data monitor item list, select «FR Wheel Speed» and «FL Wheel Speed».

2. Check if the speed indicated on the display changes in the same manner as the speedometer reading during acceleration/deceleration when the steering wheel is in the straight-ahead position.

3. If the speed indicated on the display does not change in the inspection, check the ABS wheel speed sensor. Front ABS Wheel Speed Sensor > INSPECTION">

1. Visually check the tip of the ABS wheel speed sensor for foreign particles or damage. If necessary, clean the tip or replace the ABS wheel speed sensor.

2. Disconnect the ABS wheel speed sensor connector.

3. Check the ABS wheel speed sensor cable for discontinuity. If defective, replace the ABS wheel speed sensor.

4. Connect a 12 V power supply to No. 1 terminal of ABS wheel speed sensor connector, then attach resistance to the No. 2 terminal. Rotate the wheel at about 2.75 km/h (2 MPH), and measure the voltage using an oscilloscope.

Standard value of output voltage:

0.7 — 1.4 V

5. Replace the ABS wheel speed sensor if the inspection result is not within the standard value.

Front abs wheel speed sensor

Removal

Other materials:

Assembly
CLUTCH SYSTEM > Clutch PedalASSEMBLY1. Install the stopper and pedal pad to the clutch pedal.2. Install the clutch switch to the pedal bracket.3. Clean the pedal bushing holes of the clutch pedal and the brake pedal, apply grease, and install the pedal bushings.4. Install the clutch pedal, brake ...

Ignition switch light (if equipped)
For easy access to the ignition switch in the dark, the ignition switch light illuminates when the driver's door is opened or when the driver's door is unlocked using the remote keyless entry transmitter. The light remains illuminated for several tens of seconds and then gradually turns off ...

Dtc b1577 imm control module eeprom
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1577 IMM CONTROL MODULE EEPROM1. EXCEPT FOR C0 AND C5 MODELSDTC detecting condition:• Defective keyless access CM• When inaccessible to ROM in keyless access CM.STE ...