Subaru Crosstrek Service Manual: Inspection

1. MOVING LOAD OF SUNSHADE ASSEMBLY

1. Attach a spring scale together with a cloth to the edge of sunshade assembly.

2. Pull the spring scale to check the moving load of the sunshade assembly.

Moving load of sunshade assembly:

14±6 N (1.43 kgf, 3.1 lbf±0.61 kgf, 1.3 lbf)

Moving load is larger at the beginning of pulling a spring scale, so take a spring scale reading while the sunshade assembly is sliding smoothly.

3. If the inspection result exceeds the standard, check the sunshade assembly or the rail assembly - sunroof for improper installation, and replace if necessary.

Sunshade

Removal

Other materials:

Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR CoolerREMOVAL1. Disconnect the ground cable from battery.2. Drain engine coolant. Engine Coolant > REPLACEMENT">3. Remove the center exhaust pipe. Center Exhaust Pipe > REMOVAL">4. Lower the vehicle.5. Remove the ...

Inspection
CLUTCH SYSTEM > Clutch PedalINSPECTIONMove the clutch pedal pads in the lateral direction with a force of approximately 10 N (1 kgf, 2 lbf) to check that the clutch pedal deflection is within the service limit. If it exceeds the service limit, replace with new bushings.Deflection of the clutch pe ...

Dtc c0075 wheel cylinder pressure sensor output
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0075 WHEEL CYLINDER PRESSURE SENSOR OUTPUTDTC detecting condition:Defective pressure sensorTrouble symptom:EyeSight does not operate.STEPCHECKYESNO1.CHECK STOP LIGHT SWITCH CIRCUIT.Check sto ...