SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunroof Switch
INSPECTION
1. Check the resistance between connector terminals.
Preparation tool:
Circuit tester
Terminal No. | Inspection conditions | Standard | Connector |
1 — 3 | Open | Less than 1 ? | (b): Slide switch |
4 — 3 | Close | Less than 1 ? | |
1 — 3 | Tilt up | Less than 1 ? | (a): Tilt switch |
4 — 3 | Tilt down | Less than 1 ? |
2. Replace the sunroof switch if the inspection result is not within the standard value.
Inspection
LIGHTING SYSTEM > Room LightINSPECTION1. ROOM LIGHT BULB1. Visually check the bulb for blow out.2. Check the bulb specification. General Description > SPECIFICATION">3. Replace the bulb if it is found defective.2. ROOM LIGHT SWITCH1. Check the resistance between switch terminals.Prepa ...
General diagnostic table Inspection
WHEEL AND TIRE SYSTEM > General Diagnostic TableINSPECTIONSymptomsPossible causeCorrective actionWheel is out of balance.Improperly inflated tire.Adjust the tire pressure.Uneven wearCheck the tire referring to “Abnormal tire wear” in this table, carry out the procedure and replace the ...
General description
Caution
CRUISE CONTROL SYSTEM > General DescriptionCAUTION• Before disassembling or reassembling parts, always disconnect the battery ground cable from battery. When replacing the audio, control module and other parts provided with memory functions, record the memory contents before discon ...