Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Inspection

SPEED CONTROL SYSTEMS(H4DO) > Accelerator Pedal

INSPECTION

1. CHECK ACCELERATOR PEDAL SENSOR AREA (METHOD WITH CIRCUIT TESTER)

1. Remove the glove box. Glove Box > REMOVAL">

2. Turn the ignition switch to ON. (Engine OFF)

3. Measure the voltage between ECM connector terminals.

Main sensor side

(A)

To ECM connector

Sub sensor side

(A)

To ECM connector

Accelerator pedal sensor

Accelerator pedal

Terminal No.

Standard

Main

Not depressed (full closed)

23 (+) and 29 (−)

0.4 — 1.0 V

Depressed (full opened)

2.4 — 3.7 V

Sub

Not depressed (full closed)

31 (+) and 30 (−)

0.3 — 1.1 V

Depressed (full opened)

2.3 — 3.8 V

4. After inspection, install the related parts in the reverse order of removal.

2. CHECK ACCELERATOR PEDAL SENSOR AREA (METHOD WITH SUBARU SELECT MONITOR)

1. Turn the ignition switch to ON. (Engine OFF)

2. Read the accelerator pedal opening angle signal and voltage of accelerator pedal sensor using Subaru Select Monitor. Subaru Select Monitor > OPERATION">

Accelerator pedal sensor

Accelerator pedal opening angle signal

Standard

Main

0.0%

0.4 — 1.0 V

100.0%

2.4 — 3.7 V

Sub

0.0%

0.3 — 1.1 V

100.0%

2.3 — 3.8 V

3. OTHER INSPECTIONS

1. Check that the accelerator pedal does not have deformation, cracks or damage.

2. Check for smooth operation when the accelerator pedal is depressed.

3. Check if the accelerator pedal returns to its original position smoothly when the pedal is released.

Removal
SPEED CONTROL SYSTEMS(H4DO) > Accelerator PedalREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Disconnect the connector (A).3. Remove the nut (B) securing accelerator pedal as ...

Installation
SPEED CONTROL SYSTEMS(H4DO) > Accelerator PedalINSTALLATIONInstall in the reverse order of removal.Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-lb) ...

Other materials:

Note
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunroof Control SystemNOTEFor operation procedures of each component of the sunroof control system, refer to the respective section.• Glass lid: Glass Lid">• Sunroof assembly: Sunroof Assembly">• Sunroof motor: Sunroof ...

Removal
SECURITY AND LOCKS > Remote OpenersREMOVAL1. FRONT HOOD OPENER1. Remove the opener handle.(1) Remove the cable.(2) Remove the bolt, and remove the opener handle.2. After removing the following parts, attach a string to the end of the cable - front hood and remove the cable clip and the cable.&bul ...

Dtc p0346 camshaft position sensor "a" circuit range/performance bank 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0346 CAMSHAFT POSITION SENSOR "A" CIRCUIT RANGE/PERFORMANCE BANK 2NOTE:For the diagnostic procedure, refer to DTC P0345. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0345 CAMSH ...

© 2016-2024 Copyright www.sucross.com