Subaru Crosstrek Service Manual: Inspection
SECURITY AND LOCKS > Relay and Fuse
INSPECTION
1. CHECK FUSE
1. Remove the fuse and inspect visually.
2. If the fuse is blown out, replace the fuse.
NOTE:
If the fuse is blown again, check the system wiring harness.
2. CHECK RELAY
1. Check the resistance between relay terminals.
Terminal No. | Inspection conditions | Standard | Circuit |
1 — 2 | Always | 1 M? or more |
1 — 2
Apply battery voltage between terminals 4 and 3.
Less than 1 ?
Terminal No. | Inspection conditions | Standard | Circuit |
1 — 4 | Always | 1 M? or more |
1 — 4
Apply battery voltage between terminals 2 and 3.
Less than 1 ?
Terminal No. | Inspection conditions | Standard | Circuit |
1 — 2 | Always | 1 M? or more |
1 — 4
Always
Less than 1 ?
1 — 2
Apply battery voltage between terminals 3 and 5.
Less than 1 ?
2. Replace the relay if the inspection result is not within the standard value.
Relay and fuse
...
Location
SECURITY AND LOCKS > Relay and FuseLOCATIONMain fuse boxFuse 15 A (key warning switch, turn signal & hazard unit, body integrated unit)(A)Fuse 20 A (body integrated unit, immobilizer antenna)(B ...
Other materials:
Anti-entrapment function
CAUTION
Never attempt to test this function
using fingers, hands or other
parts of your body.
The anti-entrapment function
may not operate properly if some
object gets trapped just before
the window fully closes.
NOTE
If a window detects an impact similar
to that caused by t ...
Dtc c0061 normal opening valve 1 malfunction
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0061 NORMAL OPENING VALVE 1 MALFUNCTIONNOTE:For the diagnostic procedure, refer to “C0064 NORMAL CLOSING VALVE 2 MALFUNCTION”. Diagnostic Procedure with Diagnostic Trouble Code ...
32
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code32This DTC is detected out of vehicle speed range.Increase vehicle speed high enough to allow the cruise control to function, and then perform setting operation again.If cancel code is still detected after setting cruise a ...
