SECURITY AND LOCKS > Rear Gate Latch and Actuator Assembly
INSPECTION
1. LATCH
Check if the latch operates normally.
If latch deformation, abnormal wear, or unsmooth lock operation is observed, replace the latch and actuator - rear gate.
2. ACTUATOR
Preparation tool:
Circuit tester
1. Check door lock operation
Check the door lock operation when battery voltage is applied between the terminals of actuator.
Terminal No. | Inspection conditions | Specification |
1 (+) — 2 (−) | Connect battery to the terminals | OPEN |
2. Check switch
Check the resistance between actuator terminals.
Terminal No. | Inspection conditions | Standard |
3 — 4 | OPEN | Less than 1.5 ? |
CLOSE | 1 M? or more |
3. If it does not operate properly as a result of inspection, replace the latch and actuator - rear gate.
Dtc b1832 short in curtain airbag rh squib circuit (to ground)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1832 SHORT IN CURTAIN AIRBAG RH SQUIB CIRCUIT (TO GROUND)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Curtain airbag harness (RH) circuit is shorted to ground.• Curtain airbag ...
Basic diagnostic procedure Procedure
EyeSight (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:• Start the diagnosis after the engine has started. (Cruise control main switch does not turn on even if it is pressed before the engine starts.)• When performing diagnosis, observe the legal speed limit on the road.& ...
Dtc u0424 invalid data received from hvac control module
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0424 INVALID DATA RECEIVED FROM HVAC CONTROL MODULENOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedure. Basic Diagnostic Procedure">1. OUTLINE OF DIAGN ...