SECURITY AND LOCKS > Push Button Ignition Switch
INSPECTION
1. Check the continuity between push button ignition switch terminals.
Preparation tool:
Circuit tester
Terminal No. | Inspection conditions | Specification |
4 (COM) — 5 (GND) | Always | Continuity exists |
7 (SSW1) — 5 (GND) | Push button ignition switch released > pressed | Continuity exists |
2 (SSW2) — 5 (GND) | Push button ignition switch released > pressed | Continuity exists |
2. Check the push button ignition switch operation when battery voltage is applied between the terminals of the push button ignition switch.
Terminal No. | Inspection conditions | Specification |
11 (SWIL) — 5 (GND) | Connect battery to the terminals | Goes off > Red switch illumination light |
12 (INDS) — 5 (GND) | Turns off > Switch indicator lights in green | |
13 (INDW) — 5 (GND) | Turns off > Switch indicator lights in orange |
3. Replace the push button ignition switch if the inspection result is not within the standard value.
Dtc u0416 invalid data received from vehicle dynamics control module
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0416 INVALID DATA RECEIVED FROM VEHICLE DYNAMICS CONTROL MODULENOTE:For the diagnostic procedure, refer to LAN section. Basic Diagnostic Procedure">1. OUTLINE OF DIAGNOSISDetect malfunction of CAN co ...
Installation
BRAKE > Rear Disc RotorINSTALLATIONNOTE:Before installation, remove mud and foreign matter from the caliper body assembly.1. Before installation, check the rear disc rotor. Rear Disc Rotor > INSPECTION">2. Install each part in the reverse order of removal.NOTE:When installing the rear ...
Dtc p0352 ignition coil "b" primary control circuit/open
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0352 IGNITION COIL "B" PRIMARY CONTROL CIRCUIT/OPENNOTE:For the diagnostic procedure, refer to DTC P0351. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0351 IGNITION COIL " ...